Adjust default values

hold down mceclip0.png at the same time for 2 seconds, the device will enter setup mode and the setup icon mceclip1.png will turn on.
Press "+" or "-" to switch screen. Press mceclip4.png to adjust the parameters of the current screen.

 


CO2
1. To set the maximum value of the CO2 alarm: when MAX and the maximum value are flashing, press "+" or "-" to increase/decrease the value.
2. To adjust the minimum value of the CO2 alarm: when MIN and minimum value are flashing, press "+" or "-" to increase/decrease the value.
3. Press mceclip4.png to toggle between max. and min.
4. Press mceclip3.png to save the set values and return to the previous page.

 

TEMPERATURE
Default values: min. 19°C, max. 27°C
1. “°C/°F” flash: short press "+" or "-" to switch between °C and °F unit.
2. To adjust the maximum temperature value: when MAX and the maximum value are flashing, press "+" or "-" to increase/decrease the value.
3. To adjust the minimum temperature value: when MIN and the value are flashing, press "+" or "-" to increase/decrease the value.
4. Press mceclip4.png to toggle between max. and min. settings
5. Press mceclip3.png to save the set values and return to the previous page.

 


HUMIDITY
Humidity default values: mín. 30%, max. 80%.
1. To adjust the maximum humidity value: when MAX and the maximum value are flashing, press "+" or "-" to increase/decrease the value.
2. To adjust the minimum humidity value: when MIN and the minimum value are flashing, press "+" or "-" to increase/decrease the value.

3. Press mceclip4.png to toggle between max. and min. settings
4. Press mceclip3.png to save the set values and return to the previous page.

 


DATE & TIME
1. When the numbers are flashing, press "+" or "-" to set the date & time.
2. Press mceclip4.png briefly to switch between date and time settings.
3. Press mceclip3.png to save the set values and return to the previous page.

 


"DO NOT DISTURB"
“Do not disturb” silences the alarm in a set time frame. The default time for "Do not disturb" is 22:00-08:00
1. When the numbers are flashing, press "+" or "-" to set the date & time.
2. Press mceclip4.png to toggle between max. and min.
3. Press mceclip3.png to save the set values and return to the previous page.

 

Was this article helpful?

0 out of 0 found this helpful

Have more questions? Submit a request