To turn on your SPC ETHER, simply take them out of the charging case and they will start to flash. Already switched on.
If they were already out of the case, press and hold the touch surface of both for 3 seconds to turn them on.
When the connection between the two headphones is made correctly, both LEDs will light up at the same time. After a few seconds, the LEDs of one of the headphones will stop flashing (usually the left) and the other will continue to flash
You can proceed to the link to your music player device, through the Bluetooth connection.
To turn off your SPC ETHER, you can do it in two ways:
If you store them directly in the charging case, they will disconnect from the Bluetooth device, turn off and start charging.
You can also turn off your SPC ETHER by pressing either earphone for 5 seconds. Both will then turn off.