Installation and commissioning

Lift the back cover, using the tab located at the bottom of the telephone, and remove the battery.

 

Tapa_bater_a.jpgBater_a.jpg

 

Insert the SIM card(s) and the SD card (if required) into the slots by lining up the gold contacts of the slots and the cards.

SIM.jpg

 

 

Insert the battery again by lining up the gold contacts of the telephone and the battery.

 

Contactos.jpg

 

To charge the terminal, connect the cable to the telephone's micro USB connector located on top of the phone. Check the orientation of the connector and do not force the connection if it is not immediate.

You can also connect the cable to the charging dock. As before, check the orientation of the connector and do not force the connection if it is not immediate.

Carga.jpg

 

Before you start to use it, remember to remove the screen protector.

 

Protector.jpg

 

Press and hold the power key for a few seconds to turn on the telephone. Enter the PIN assigned to your SIM card.

Encender.jpg

 

To turn off the telephone, press and hold this key for a few seconds or the 'End call' key.

Apagar.jpg

 

 

NOTE: The personal identification number (PIN) protects the SIM cards from unauthorised use. The PIN unlocking key (PUK number) allows you to unlock a blocked PIN. The PIN and PUK are provided with the SIM card. For more details, contact your operator.

Was this article helpful?

7 out of 19 found this helpful

Have more questions? Submit a request