How to modify the alarm notifications

If you do not want to receive all the notifications that the alarm sends, such as arming/disarming the system, you can disable them via the advanced functions settings on the control panel.

To do this, access setup mode in the panel by entering your administrator code + Enter.

* The administrator code will be 123456 if you have not changed it.

The system will beep, then it will be in setup mode.

Then, in order to enable or disable the arm/disarm notifications and only receive the alarm triggers you must enter the following code, depending on what you want to do.

Notificaciones armado/ desarmado


Disable armed/disarmed notifications


Enable armed/disarmed notifications

To exit setup mode press the Esc key.


If you want to know more about the advanced setup options, go to this article.

Was this article helpful?

0 out of 0 found this helpful

Have more questions? Submit a request



Article is closed for comments.