LOADLOAD.
To charge the watch, connect the supplied charging cable to a standard USB power supply (5 volts) and to the magnetically attached charging terminals of the watch, as shown in the figure:.
Recommended power supply: Input 100-240Vac, 50/60Hz; output 5V 1000mA. Recommended power supply: Input 100-240Vac, 50/60Hz; output 5V 1000mA.
During charging, a short press on the power button displays the battery icon with the full status .
At 100%, the message ‘Charge complete’ and the battery full icon in green will appear.
Recommended charging time with standard charger is less than 3 hours.
On the watch you can check the battery status in the status bar:.
When the battery is low, an informative vibrating alert appears on the watch display. This warning appears when the battery reaches 15%, 10% and 5%. .
Similarly, with low battery, corresponding notifications are produced in the SMART YOU app informing the family member. .
AUTONOMY:.
The autonomy values depend largely on the configuration of the watch and the activity and functionalities performed. These values have been obtained according to the use:.
- The autonomy in a typical use is 3 days. Typical use: screen brightness at 50%, 1 GPS location every hour, Wi-Fi off, and daily: 5 minutes of screen activation, 1 minute of calls, 5 chat messages. .
- Autonomy in intensive use is 2.5 days. Intensive use: screen brightness at 75%, 1 GPS location every 9 minutes, Wi-Fi on, and daily: 150 times of screen activation, 4 minutes of calls, 1 video call of 2 minutes, 20 chat messages. .
- In battery-saving mode saving mode the battery life is 4 days. Battery saver: Typical usage: screen brightness at 20%, Wi-Fi off, and daily: 100 times screen activation, 2 minutes of calls, 2 chat messages, 1 GPS location.