UBICACIÓN DE LA BASE
The base and handset must have a good radio signal, so place the base near:
- The telephone line socket and the power socket (mains).
- The best location is in the centre of the area. If you have little coverage, try changing the base location.
- Do not place it in a place where it is exposed to direct light and/or there is humidity.
- The coverage is 50 metres. Do not install near electrical appliances as this could reduce coverage and sound quality.
PLACEMENT AND INSTALLATION OF THE HANDSET/BASE
- Insert the end of the adapter into the base connector (13) and the other into the socket.
- Plug the base line cable (14) and the other end into the line socket.
- Install the batteries in the laptop. Open the battery compartment. Install the batteries (check the polarity "+" and "-"). Replace the cover.
- Place the handset on the base to charge the batteries, at least 14 hours.
- The Handset is pre-programmed to link with its Base displaying SPC and the Handset number on the screen. If this does not happen, unplug the power cord from the base, remove the handset batteries, and repeat the process in reverse.
BATTERY INFORMATION
The battery icon flashes when charging starts and stops flashing when the battery is fully charged.
OUT OF COVERAGE NOTICE
If the call quality worsens or is poor during a conversation, you must go to the base, otherwise the communication will be cut off. When coverage is lost icon flashes and the display shows NO SIGNAL.