This telephone should only be connected to lines with the additional
multi-frequency dialing method.
Connect one end of the ribbon cable to the LINE jack (15) on the
back of the phone and the other end to the phone jack.
Connect one end of the telephone cord to the cord jack on the
bottom of the telephone and the other end to the other cord jack
on the left side of the base. Make sure you hear a tone when you
lift the handset.
To complete the installation, select one of the two mounts: Table
mount or Wall mount (hanging on the wall).
For wall mounting, drill a hole in the wall, insert a screw and attach
the base of the telephone in the recess (16) provided for this purpose
on the underside of the telephone. Make sure that the device is
perfectly fixed to the wall.
− To keep the handset hanging, you must remove the hook section,
turn it 180° and replace it with the tab facing up. This prevents the
handset from falling off when you hang it up.